HOTweezers M-20 ESD safe power supply for use with HOTweezers thermal wire strippers.
By using the M-20 Power Supply it is possible to adjust the tip temperature from 149°C (300°F) to 788°C (1450ºF), therefore the stripping temperature can be maintained at a level very near the softening point of the insulation material without charring or igniting it.
Featuring an on/off switch, "HI" and "Low" jacks, a temperature control, and a unique holder for the HOTweezers hand unit.
Placing the tweezers in the hand unit puts the temperature into 'idle' mode, then when you pick them up again they will adjust to the original temperature setting.
Please note, this is the power supply only.
This power supply unit is CE marked, meaning it is safe to use in the European Economic Area.
If your question has not yet been answered below, use the form below to ask something about this product.
Please note only use this form to ask a specific question about this product such as techinal spec. If you wish to make a general enquiry please use our Contact Us form instead